I’ve been spending a lot of time lately playing around with 555 timer chips and wanted to quickly share my latest creation. This project uses four 555 timers each set up as a standard astable oscillator. I’ve then connected the output from pin 3 of each oscillator to the control voltage at pin 5 of the next subsequent chip. Essentially this means each 555 timer is working as an LFO for the next oscillator to it’s right. I also increased the size of the capacitor between pin 6 and ground of the two left-most oscillators in order to lower their frequency.
I was quite pleased with the range and depth of sounds it produced however, it should be said that I built this as a proof of concept and it is not fully flushed out. I would be very interested to try a similar setup with a different waveform. I feel like this idea would really come into it’s own if used with a triangle or sine wave oscillator which produced a wider range of tones. I have also been experimenting, with some success, with adding capacitors between the output and control voltage inputs to smooth the square wave slightly and create a saw tooth pattern. Without an oscilloscope on hand however this is proving difficult to optimize.
This is also a circuit which can be easily expanded by adding additional oscillators and admittedly there is a little voice screaming in my head to take it to it’s logical conclusion. I expect in my near future I’ll spend a rainy afternoon stringing together as many 555 circuits as I can fit on my breadboards and see what I end up with. I’ll be sure to share the results.